Optical Trapping with Focused Surface Waves

Near-field optical trapping can be realized with focused evanescent waves that are excited at the water–glass interface due to the total internal reflection, or with focused plasmonic waves excited on the water–gold interface. Herein, the performance of these two kinds of near-field optical trapping techniques is compared using the same optical microscope configuration. Experimental results show that only a single-micron polystyrene bead can be trapped by the focused evanescent waves, whereas many beads are simultaneously attracted to the center of the excited region by focused plasmonic waves. This difference in trapping behavior is analyzed from the electric field intensity distributions of these two kinds of focused surface waves and the difference in trapping behavior is attributed to photothermal effects due to the light absorption by the gold film.     

不同声音偏好的游客声景观主观评价差异——以丽江大研古镇为例*

古镇作为集自然景观与人文景观一体的景区，具有丰富的声音类型。本研究以大研古镇为例，通过实地调研探究不同声音偏好的游客对古镇声景观的主观评价差异。基于游客的声音偏好，将游客分为偏爱自然声和偏爱人工声两大类。通过因子分析提取游客声景观主观评价的5个主因子：大小、音质、效价、偏好和唤醒。进一步分析发现，这5个因子具有一定的层级性，其中从大小到唤醒代表声景观评价从声音的物理属性向声音的联想评价逐级提升。其中在低层级评价(大小、音质)中，偏好自然声的游客和偏好人工声的游客无显著差异，低层级评价具有稳定性；而在高层级评价(效价、偏好和唤醒)中，偏好人工声的游客更关注古镇声景观的淳朴性和遗产性。因此，游客对声景观的主观评价可视为一种指标，判断景区声景所处的评价阶段，从而为景区声景观改善提供更有针对性的建议。     

浮升力和流动加速对超临界CO2管内流动传热影响

基于单相流体的概念,超临界流体的异常传热行为已经被研究很多年了,但是关于其流动传热机理仍没有统一的认识.本文通过理论分析和实验研究了超临界二氧化碳在竖直管内向上流动过程中,浮升力和流动加速效应对其流动结构和传热过程的影响.结果表明,没有确凿的实验证据表明超临界流体的异常传热行为是浮升力和流动加速直接导致的,存在的估计浮升力和流动加速效应准则均是在常物性流体的基础上,做了大量假设得出的,不同的研究者采用浮升力和流动加速准则分析超临界流体的传热恶化得出的结论不一致.最后,基于拟沸腾理论分析超临界流体的传热恶化过程,提出超临界沸腾数区分了超临界流体正常传热与恶化传热的转换边界,为超临界流体流动传热研究提供新思路,超临界沸腾数对建立用于不同技术的超临界流体动力循环的最佳运行条件具有重要意义.     

DFT mechanistic study of the H2‐assisted chain transfer copolymerization of propylene and p‐methylstyrene catalyzed by zirconocene complex

DFT computations have been performed to investigate the mechanism of H₂‐assisted chain transfer strategy to functionalize polypropylene via Zr‐catalyzed copolymerization of propylene and p‐methylstyrene (pMS). The study unveils the following: (i) propylene prefers 1,2‐insertion over 2,1‐insertion both kinetically and thermodynamically, explaining the observed 1,2‐insertion regioselectivity for propylene insertion. (ii) The 2,1‐inserion of pMS is kinetically less favorable but thermodynamically more favorable than 1,2‐insertion. The observation of 2,1‐insertion pMS at the end of polymer chain is due to thermodynamic control and that the barrier difference between the two insertion modes become smaller as the chain length becomes longer. (iii) The pMS insertion results in much higher barriers for subsequent either propylene or pMS insertion, which causes deactivation of the catalytic system. (iv) Small H₂ can react with the deactivated [Zr]?pMS?PP_n facilely, which displace functionalized pMS?PP_n chain and regenerate [Zr]? H active catalyst to continue copolymerization. The effects of counterions are also discussed. © 2014 Wiley Periodicals, Inc. J. Polym. Sci., Part A: Polym. Chem. 2015 , 53, 576–585     

Flame-retardant effect of cross-linked phosphazene derivatives and pentaerythritol derivatives on polypropylene

Journal of Thermal Analysis and Calorimetry - A phosphazene-based flame retardant (PBFA) was synthesized by hexachlorocyclotriphosphazene and N-aminoethylpiperazine. To improve the flame retardancy...     

Positive ground state solutions for Schrödinger–Poisson system with critical nonlocal term in ℝ3

This paper is dedicated to studying the following Schrödinger–Poisson system $$\left\{\begin{array}{ll}-\mathrm{\Delta }u+V(x)u-K(x)\varphi |u{|}^{3}u=a(x)f(u),& x\in {ℝ}^3,\\ -\mathrm{\Delta }\varphi =K(x)|u{|}^5,& x\in {ℝ}^3.\end{array}\right.$$ Under some different assumptions on functions V(x), K(x), a(x) and f(u), by using the variational approach, we establish the existence of positive ground state solutions.     

平顶飞秒激光经圆锥透镜在熔融石英中成丝及超连续辐射

实验研究了平顶飞秒激光经圆锥透镜后在熔融石英中的成丝及超连续辐射.与高斯飞秒激光的成丝对比发现,平顶飞秒激光可以获得在圆锥透镜焦深区域内强度分布更为均匀的等离子体细丝,这一特征更有利于飞秒激光在固体介质中进行微纳加工等领域的应用.并且,在不损伤熔融石英的条件下,平顶飞秒激光成丝可以获得更高能量、更高转换效率的超连续辐射,这是因为若产生光强相近的细丝,平顶飞秒激光所需的初始激光能量更高,此激光能量下产生的细丝长度更长、均匀性更好.